Operating Principles & Mechanism Designs

 WEEK 13: Operating Principles & Mechanism Designs

For this week's topic, we learnt about operating principles and mechanism designs. 

Operating principle: how things work
Mechanism design: enables & enhances principles

Examples of where operating principles are applied:
1. Brewing coffee, operating principle: leaching of coffee solubles 🍵
2. Steam traps, operating principle: specific gravity

Examples for mechanism:

- Actuators
- Cams
- Gears 🔧
- Lever
- Ratchets
- Spring

We were then tasked to create a ping pong ball shooter that includes mechanisms mentioned above for the propulsion and reloading of balls.

CA2 Report Part 4: Mechanism Design 



Propulsion principle: The toy uses spring as the energy storage mechanism to propel the ping pong ball. It is a fully manual system that works by cocking the fore-end/pump back to load the ball into the chamber as well as load the spring and hammer into their firing position. The firing spring is held back by a lever system connected to the trigger. When the trigger is pulled, the system unlocks the firing spring and hammer, there by allowing them to hit the firing mechanism placed at the back of the to hit the ball and launch it.


Ball loading: The ball is loaded from the bottom into a spring charged magazine beneath the chamber of the launcher. As said in the propulsion principle, the ball is loaded into the chamber by pulling back the firing mechanism and using the spring in the magazine to push the ball up into the chamber. The ball is then locked into the chamber by cocking the fore-end/pump forward into its original position.


Practical 4: Game design with carboard (!! i didnt attend this practical session!!)

For this practical, we were tasked to design and make a marble run machine out of cardboard. The machine should also have at least 1 manually operated mechanism and it must be able to keep a marble in continuous motion for 30 seconds. 

Sketch of our design (inspired by a YouTube video we watched):


We planned to use a spiral to transport the marble to the top, which will then lead to a 2 way vortex. We also planned to include stairs to the machine which operates on CAMS and gears. 

For the spiral carrier, Ruba and I decided to add a handle so that we can spin the spiral manually. However, on the day of practical, the handle was too flimsy to be used. As for the spiral structure, we peeled 1 layer of the carboard and layered them on top of each other so that it is sturdier. 💪

                            

For the stairs, i heard from my group mates that they did not have enough time to include this mechanism on the day of practical.



Jun Hao prepared the stairs, cams and gears before the practical session.

For the vortex, we made use of a circle with 2 holes cut in the middle to allow 2 different paths.


For the spiral slope, we cut 6 semi circles so that they can be placed in an angle and a slope can be created. I suggested to add corrugations to the surface of the slopes to slow down the marble.



During the practical session, my group mates assembled the main parts using zip-ties and L-brace. 


they also created slopes
bottom slope:


slope where the spiral carrier rests on:

final product:

side view:

Video:

Reflection:
I was not able to attend the practical session because I was sick. I still learned quite a few things when doing the preparations for this practical. We learned how to make a vortex, how to make gears using cardboard and how to make a slope using semi circles. I did miss out on quite a lot but I still enjoyed my time when doing the preparations even though it was quite tedious. 👌













Comments